Publicité
Les langues disponibles
Les langues disponibles
35LITER SOLAR SHOWER INSTRUCTIONS
Assemble Instructions
Set up your solar shower in a place that is exposed to direct sunlight as long as possible.
1. Connect shower head to black shower body tube.
NOTE: Don't use wrench. Don't forget the gasket.
2. Mount the shower base to concrete slab or wood base with four bolts, nuts and gaskets.
Recommend use wrench.
3. Connect footwash to the shower.
4. Connect hose adaptor to inlet of shower.
5. Connect garden hose to hose adaptor and water supply.
First Usage
1. Turn the shower handle to FULL ON HOT position.
NOTE: Filling tube with valve in hot position ensures no air pockets are trapped in shower.
This procedure is used for first usage only.
2. Turn on water supply to garden hose to fill the shower. It will take 5 to 6 minutes to fill up the
shower.
3. When water flows from shower head, turn the shower handle off. Turning shower handle off
makes water begin heating in tube.
4. Depending on sunlight and outside temperature, the shower will take two to three hours to fully
heat water.
5. WARNING: To avoid scald, pay attention to turn shower handle to cold water (blue) direction
before using the shower. Then setting to desired temperature.
Winterization
1. Turn off and disconnect garden hose.
2. Open handle to full on hot position and allow water to drain from draining hole (about 7 to 8
minutes).
NOTE: Don't tough or turn shower handle while draining water, otherwise water will stop draining.
3. Clean and dry the shower parts.
4. Move shower from outdoor to indoor. Store it in dry and warm place during winter season, and
prevent it from frostbite.
Warning
1．DO NOT USE SALT WATER OR ANTI-FREEZINE METHODS.
2．WATER PRESSURE: MAX 3.5BARS
3．ALWAYS START YOUR SHOWER FROM COOL TO AVOID SCALD.
5
Publicité
