ECOheat R-Connect Mode D'emploi Et D'installation page 18

II. Installation of the thermostat on wall:
B1
III. Installation of the receiver:
1. Install the base on the wall and pull the cable through as depicted.
2. Using a small screwdriver, carefully loosen the latches located at the base of the receiver. You can
then separate the front panel from the backplate.
3. Position the receiver backplate on the wall, fixing it into place using the screws provided.
4. Terminate the cables to the RF-Switch as shown in the wiring diagram, tighten the retaining screw
on the base.
5. Mount the front panel onto the backplate, press the power button, the power LED 2 will illuminate.
18 | ecoheat R-Connect Bedienungsanleitung
2 3 4