Princeton Tec Fuel Notice D'utilisation Et D'entretien

ENGLISH
Battery Installation
– See Battery Installation Diagram
• 3 AAA
• Alkaline (LR03)
• Rechargeable NiCad or NiMH
Princeton Tec cares about the environment and
recommends recycling batteries. For more
information about battery recycling, please go
to: www.batteryrecycling.com
To install the batteries, use the tool on the
headband to unlatch the door. Open the Fuel
case by popping the door latch over the catch
and rotate the door open.
Install three AAA batteries according to the
polarity markings on the inside of the cabinet.
Observe proper battery polarity when installing the
batteries. Improper installation of the batteries will
damage the light and void the warranty.
Rotate the door to the closed position, squeeze
the body between your forefingers and thumb to
snap the door latch over the catch.
WARNING
!
• Never mix fresh and used batteries.
• Never mix different battery brands or
chemistry types.
• Always remove drained batteries immediately.
• Remove batteries during long periods of
storage.
NOTE: Rechargeable NiCad or NiMH batteries
may result in reduced brightness due to lower
nominal voltage.
Switch Operation
– See Switch Operation diagram
Modes (High, medium, low and flash) are selected
by pressing and releasing the button within 1.5
seconds of the previous button press.
There are two ways to turn the Fuel off. You can
cycle through the modes until you reach off, or if
more than two seconds has passed since the
previous button press the next press of the
button will turn the light off.
Power Consumption
Refer to the burn time chart for performance data
for different battery types and mode settings.
**Princeton Tec calculates total burn time as the
time it takes for the light source to produce a
minimum of 0.25 lux at 2 meters. 0.25 lux is
about the equivalent of a full moon on a clear
night.
**The times listed in this chart assume you start
with fresh batteries and use only one mode.
Troubleshooting
If the Fuel fails to light:
• Check the batteries for proper installation.
• Replace batteries if proper installation is confirmed.
Figure 1 – Switch Operation
press 1x = High
press 2x = Med
press 3x = Low
press 4x = Flash
4 Ultrabright
* Princeton Tec calculates total burn time as the time it takes for the light source to produce a
minimum of 0.25 lux at 2 meters. 0.25 lux is about the equivalent of a full moon on a clear night.
* Princeton Tec berechnet die Gesamtbrenndauer bezogen auf eine von der Stirnlampe erzeugte
minimale Beleuchtungsstärke von 0,25 Lux in 2 Meter Abstand. 0,25 Lux entsprechen in etwa
der Beleuchtungsstärke des Vollmonds in einer klaren Nacht.
* Princeton Tec définit la durée totale d'éclairage comme le temps nécessaire à la source
lumineuse pour produire un minimum de 0,25 lux à 2 mètres. 0,25 lux équivaut à peu près à la
luminosité d'une pleine lune dans un ciel nocturne dégagé.
Figure 2 – Battery Replacement
1
Use tool on headstrap to open battery compartment
Utilisez l'outil attaché à la sangle de la frontale pour
ouvrir le compartiment des piles.
Verwenden Sie zum Öffnen des Batteriefachs das
am Kopfband befestigte Werkzeug.
3
* The times listed in this chart assume you start with fresh batteries and use only one mode.
* Les durées mentionnées dans le présent tableau sont calculées sur la base de l'utilisation de piles
neuves et d'un seul mode d'éclairage.
* Bei den in der folgenden Tabelle aufgeführten Zeiten wird vorausgesetzt, dass Sie neue Batterien und
lediglich eine Leuchtstärke verwenden.
• Check the light for water contamination on
the circuit board. The light will resume
normal operation once the water is shaken
or blown out and the light is left open until
completely dry. If the light has been
contaminated with salt water, flush the unit
with fresh water and dry as described above.
USA– International 5-Year Warranty
WARRANTY – Princeton Tec warrants this
product to be free from defects in workmanship
and materials under normal use for as long as
you own this product. This warranty covers all of
the component parts of the product except
batteries. This warranty does not cover
deterioration due to normal wear or damage due
to misuse, alteration, negligence, accidents, or
unauthorized repair. Princeton Tec will repair or
replace parts which are defective in workman-
ship or materials.
Your authorized Princeton Tec Dealer and
Princeton Tec are the only facilities authorized to
repair the product. After (3) unsuccessful
attempts (within the warranty period) to repair
the product, you have the right to elect
replacement of the product or a refund of the
purchase price less allowance for use of the
product. NO INCIDENTAL OR CONSEQUEN-
TIAL DAMAGES ARE INCLUDED IN THIS
WARRANTY. (Some states do not allow the
exclusion or limitation of incidental or
consequential damages, so the above
limitations or exclusions may not apply to you.)
This warranty gives you specific legal rights, and
you may also have other rights which vary from
state to state.
Princeton Tec reserves the right to change
product specifications without notice.
Opération de commutation
120H
LOW
LEDs
DISTANCE (Meters)
Remplacement des piles
2
4
FOR CALIFORNIA RESIDENTS:
WARNING: This product contains Bisphenol A
(BpA) a chemical known to the State of
California to cause birth defects or other
reproductive harm.
Return Policy
If your light fails to operate, follow these simple
steps:
1. Check batteries. Replace if necessary.
2. To send your light in for repair or
replacement, first contact Princeton Tec
customer service on 1-800-257-9080 to
request an RMA number. Please have your
light model, date of purchase and a brief
description of the fault you are experiencing.
No warranty repairs will be accepted without
an RMA number.
3. Return the light without batteries to:
Princeton Tec, PO Box 8057 Trenton NJ
08650. Postage due and freight collect items
will not be accepted.
Upon receipt your light will be processed in
about two weeks. Please allow additional
time for return transportation from NJ.
Princeton Tec
PO Box 8057,
Trenton, NJ 08650
Phone: 609-298-9331
Fax: 609-298-9601
www.princetontec.com
© 2018 Princeton Te
Betriebsartenschalter
74H
HIGH
100H
MED
150H
FLASH
24 40
Einlegen der Batterien
c
44