Publicité
Les langues disponibles
Les langues disponibles
• Select a suitable location for the beverage and wine center on a hard even surface away from direct sunlight or heat
source (e.g., radiators, baseboard heaters, cooking appliances, etc.). Any floor unevenness should be corrected with the
leveling legs located on the front and rear bottom corners of the beverage and wine center.
• Your beverage and wine center is designed for freestanding installation only. It is not designed for built-in application.
Note: This unit is for indoor use only.
Use of Extension Cord
• Avoid the use of an extension cord because of potential safety hazards under certain conditions. If it is necessary to
use an extension cord, use only a 3-wire extension cord that has a 3-blade grounding plug and a 3-slot outlet that will
accept the plug. The marked rating of the extension cord must be equal to or greater than the electrical rating of the
appliance.
FEATURES AND USE
Initial Setup
1. Plug the unit into an electrical outlet. You will hear a beep, which is normal. The display will revert to the actual internal temperature.
2. The control panel
Control Panel Settings
This unit can be adjusted from temperatures between 40ºF to 61ºF. (4.4ºF to 16.1ºC).
The LED display shows the actual internal temperature. Your beverage and wine center when it is first turned on, will
have a factory setting of 46ºF(7.7ºC).
Note: It is normal for the actual temperature to vary slightly during normal operation.
Control Panel Auto-Lock
Your beverage and wine center has an automatic control panel lock. You may manually activate or deactivate the control
panel lock by pressing the control pad
pad
before making a selection. The control panel lock will automatically activate if the control panel is not
touched for 30 seconds.
F
will be active. You must press
F
. To operate any of the functions on the control panel, press the control
before accessing any of the control pads.
F
F
7
RMF-BC-128SS
F
Publicité
