Publicité
During Assembly
Make sure the base is square by measuring the diagonals and level by using a spirit level.
You may use silicone lubricant spray in order to help you slide the panels into the profiles.
Do not spray the polycarbonate panels.
Use a rubber mallet if necessary.
All panels with the stamped words "THIS SIDE OUT" must be facing out to create
full UV protection. Remove plastic sticker as panels are locked in place.
When encountering the information icon, please refer to the relevant
assembly step for additional comments and assistance.
This icon indicates
that the installer should
be inside the product.
Wi
Attention
Di
This icon indicates that
the installer should be
outside the product.
During assembly use a soft surface below the parts to avoid scratches and damages.
W
Steps
Step 10: Make sure the base is square by measuring the diagonals and level by using a spirit level.
Steps 14: Part 7180 is used for assembly assistance.
Steps 29: After installing the gutter, it is mandatory to remove and discard (Part 7180).
Steps 50+51: Please repeat steps 46-48.
Step 61: Please add silicone on the outer area of parts 7581 & 7582 as illustrated.
Step 82: In case the window is not properly aligned, loosen the screws, adjust the profile and
re -tighten the screws.
Step 100: Make sure the cable is threaded in the hole (#7327) and does not interfere with the
window'opening.
Step 101: Anchor the greenhouse to the ground by using part 7331 for hard surface or part 7336
for soft surface.
Step 103: Stretch the cable by using part 7332.
* Please tighten all screws when completing assembly.
.
Screws 411 and nuts 412 & 466 are used throughout the assembly process.
.
Screws 411 are to be assembled from the outside and nuts 412 & 466 from the inside of the
greenhouse.
.
If not specified otherwise, do not fasten screws and nuts (411, 412 & 466) more than
2-3 turns only. Do not tighten them until completion of the panels' assembly.
These 2 icons indicate if screws' tightening is required or not.
. However, in some steps, temporary tightening of a few screws may be needed to prevent
a profile from falling.
Note: Firmly connect the product to a level surface immediately after completion of the
assembly.
Anchoring this product to the ground is essential to its stability and rigidity.
It is required to complete this stage in order for your warranty to be valid.
Publicité
