Publicité
Les langues disponibles
Les langues disponibles
English
CAUTION
Using this grinder with a carbon brush which is
worn in excess of the wear limit will damage the
motor.
NOTE
Use HITACHI carbon brush No. 59 indicated in Fig. 6.
5.
Replacing carbon brushes:
<Disassembly>
(1) Loosen the D4 tapping screw retaining the brush
cover and remove the brush cover.
(2) Use the auxiliary hexagonal wrench or small
screwdriver to pull up the edge of the spring that is
holding down the carbon brush. Remove the edge of
the spring toward the outside of the brush holder.
(3) Remove the end of the pig-tail on the carbon brush
from the terminal section of brush holder and then
remove the carbon brush form the brush holder.
<Assembly>
(1) Insert the end of the pig-tail of the carbon brush in
the terminal section of brush holder.
(2) Insert the carbon brush in the brush holder.
(3) Use the auxiliary hexagonal wrench or small
screwdriver to return the edge of the spring to the
head of the carbon brush.
(4) Mount the tail cover and tighten the D4 tapping
screw.
WARNING
Never use any accessories other than those mentioned below.
The use of any accessories other than those mentioned below or attachments not intended for use
such as cup wheel, cut-off wheel or saw blade is dangerous and may cause personal injury or property
damage.
NOTE
Accessories are subject to change without any obligation on the part of the HITACHI.
STANDARD ACCESSORIES
Wrench (Code No. 937913Z) ....................................1
Hexagonal bar wrench (Code No. 872422)...............1
Side Handle (Code No. 322411)...............................1
OPTIONAL ACCESSORIES...sold
separately
Depressed center wheel (10pcs. per package)
7 " ( 1 8 0 m m ) e x t e r n a l d i a . × 1 / 4 " ( 6 m m )
thickness × 7/8" (22.23 mm) hole dia.
(Code No. 701070)
9 " ( 2 3 0 m m ) e x t e r n a l d i a . × 1 / 4 " ( 6 m m )
thickness × 7/8" (22.23 mm) hole dia.
(Code No. 701090)
NOTE
Specifications are subject to change without any
obligation on the part of the HITACHI.
14
6
Service and repairs
All quality power tools will eventually require servicing
or replacement of parts because of wear from normal
use. To assure that only authorized replacement
parts will be used, all service and repairs must be
performed by a HITACHI AUTHORIZED SERVICE
CENTER, ONLY.
7
Service parts list
CAUTION
Repair, modification and inspection of Hitachi
Power Tools must be carried out by a Hitachi
Authorized Service Center.
This Parts List will be helpful if presented with
the tool to the Hitachi Authorized
Service Center when requesting repair or other
maintenance. In the operation and maintenance
of power tools, the safety regulations and
standards prescribed in each country must be
observed.
MODIFICATIONS
Hitachi Power Tools are constantly being improved
and modified to incorporate the latest technological
advancements.
Accordingly, some parts may be changed without prior
notice.
ACCESSORIES
Publicité
