Publicité
Les langues disponibles
Les langues disponibles
OPERATION INSTRUCTIONS
● Place the heater on a firm level surface free from obstructions, and at
least 3ft. away from any wall and any other objects such as furniture,
curtains, plants orcombustible material.
● With the Power and Setting Control "C" in the "0" position, plug the
heaterinto a grounded 120V outlet.
● Turn the heater "ON" by turning the Power and Setting control "C"
clockwiseto your desired power setting (1, 2, 3). The Power Indicator
Light "A" willilluminate.
● Turn the Thermostat Control "B" to your desired setting from "MIN" to
"MAX".
SETTINGS FOR OPTIMUM COMFORT
1. Turn the thermostat control clockwise to the highest position to start
heater. Allow heater to operate and warm up the room.
2. When the desired temperature/comfort level is reached, lower the
temperature setting by turning the Thermostat Control counter-clockwise
until the heater stops operating.
3. The thermostat will automatically maintain the pre-set temperature level
by turning the heater ON and OFF.
NOTE: There will be temperature variance measured at the internal
sensor, when the ambient temperature drops below the set temperature, it
may take a longer time for the internal sensor to cool down, and then
re-activate the heater to turn on again. If the ambient temperature is too
low, raise the set temperature level for constant heat.
NOTE: It is normal for the heater to cycle ON and OFF as it maintains the
preset temperature. To prevent the unit from cycling, raise the temperature
setting.
CAUTION:
that shuts the unit off if it overheats due to abnormal temperatures. At this
time, the "A" Power Indicator light goes off. If this occurs turn the heater
"OFF", unplug it, and inspect and removeany objects on or adjacent to the
heater. Allow it to cool for a few minutes, plug it backin, and resume
normal operation.
Note: This heater includes a safety tip over switch, which will shut the
heater off in caseit is tipped over. If at any time, the heater does tip over,
please put the heater back inthe upright position (wheels on bottom,
controls on top). The heater will resume itsnormal operation.
This heater includes an Overheat Protection System
4
Publicité
