Publicité
Les langues disponibles
Les langues disponibles
Table fan
Figure 1 illustrates the parts of this fan. After removing fan from the package, check to make sure all of the
parts are present.
Fig. 1
1. Front grill
2. Fan blade
3. Nut
4. Sleeve (discard)
5. Oscillation knob (on top of motor casing)
6. Latch
7. Blade cap
8. Rear grill
9. 3 speed switches
10. Base
11. Retaining Pin
ASSEMBLY
1. Attach the fan base to the fan body using the four screws included.
2. Place the fan base on a firm, stable surface, such as a table or counter top.
3. Remove the plastic sleeve from the shaft.
4. Secure the rear grill to the motor casing with the plastic nut. The handle should be at the top. Turn it
clockwise to tighten.
5. Slide the blade onto the shaft pin, pushing until it is firmly in place.
6. Test the blade operation by rotating it with your hand. There should be no friction with the other parts. If
blade does not rotate freely, repeat steps 4-5.
7. Place the blade cap on shaft pin and turn counter-clockwise until tight.
8. Ensure that the latches on either side of the rear grill are open. Place the front and rear grills together and
close the side latches. If they do not fit securely together, repeat the procedure.
OPERATING INSTRUCTIONS
Place the fan on a safe flat surface where it cannot fall or be pulled by the cord. Plug the fan into a 220V/50Hz
outlet and follow the operating instructions:
This fan is equipped with three fan speeds to allow optimal air comfort.
0- Pressing this button will power the fan OFF.
1- Pressing this button will power the fan ON at a LOW speed setting.
ENGLISH
2
Publicité
