Facem TRE SPADE ITALY DCT2002 Mode D'emploi page 17

CUBE Version:
The maximum outer section is cm 27x27; the in-
side of the tunnel has cm 25x25 section, and the
length is 35 cm.
The drawers measure cm 25x18 each.
The heating resistance absorbs 500 watts and the
switching on is adjusted by a manual thermostat.
POSITIONING
THE DEHYDRATOR:
As for any electrical apparatus, the motor unit
must not come into direct contact with water or
vapour sources. The dehydrator must therefore
be placed at due distance from taps, sinks and
basins, pools and sheltered from rain or from pos-
sible water splashes.
During operation the dehydrator releases mois-
ture which must not stagnate in the surrounding
environment so as not to slow down or prevent
the drying process. It is therefore recommended
to place it in a spacious room or, however, in a
room which is not sealed from the outside envi-
ronment.
Avoid moist environments such as laundries, cel-
lars etc.
Do not position the hatch or motor unit toward
walls or obstructions; leave at least 25 cm space
around these two components so as to allow prop-
er air and moisture suction.
CLEANING
AND MAINTENANCE:
No particular attention is required. To clean the
dehydrator avoid using abrasive cloths or tools
that might impair the appearance; do not use sol-
vents on the plastic and painted parts.
It is recommended to use a cloth slightly damp-
ened with water and neutral detergent. Check on
regular basis the suction grid and make sure is free
from any filaments and fluff, which could compro-
mise the normal air circulation. If clogged, remove
it using an air jet.
The drawers can be washed with hot water and
detergent, either by hand or in the dishwasher.
Important
ENTFERNEN DER
- always unplug the power cable from the power
SICHERHEITSVORRICHTUNGEN
STRENGSTENS
socket in view of any intervention.
VERBOTEN
- perform a complete washing of the tunnel and
N. 91.001.065
the drawers prior to the first use;
- never remove the protection of electrical parts
in the motor unit;
- do not use water directly on the appliance or
near it;
IM BRANDFALL
KEIN WASSER AUF
- do not immerse the motor unit in water;
ELEKTROANLAGEN
DIE UNTER STROM STEHEN
N. 91.001.066
HOW TO USE
THE APPLIANCE
CUBE Version:
REINIGEN UND/ODER
SCHMIEREN BEI
MASCHINENBETRIEB
STRENGSTENS VERBOTEN
N. 91.001.068
Position the master switch on (I) to fed power to
the dehydrator. The fan will start to rotate to its
maximum speed. At this point, by acting on the
adjusting knob (fig.1) the operating temperature
can be varied from 30°C to 68°C. The adjusting
knob adjusts the temperature of the air flow by
operating directly on the thermostat. During ope-
ration a "click" is heard whenever the thermal
conditions set by the thermostat is reached.
To define the best drying degree, access the
drawers through the inspection hatch located on
the appliance rear.
The operating cycle has to be stopped after the
necessary drying degree has been reached.
Made in Italy
English
Fig. 1
15