Publicité
®
R&S
ESCU-ZZA
Table 3-1: R&S ESCU Bias Unit 19" 1HU rackmount kit parts list
Reference
(See also
Figure
3-1)
(See also
Figure
3-1)
Table 3-2: Other parts list (to be ordered separately)
Reference No.
(See also
Figure
3-1)
3.2
Assembly
To avoid damaging the equipment, use the appropriate tools listed below:
● Phillips screwdriver for M3x6 screws
● Hex screwdriver for M5 Hex screws and nuts
3.3
Preparing for rackmount configuration
To install the R&S ESCU 19" 1HU rackmount kit with a Bias Unit
1. NOTICE! Excessive tightening of the screws can damage the equipment. Too
weak tightening can cause the device to drop from height.
To avoid damaging or dropping the device, ensure that you fix the device
properly.
Installation Instructions 5602.9960.02 ─ 02
Preparing for rackmount configuration
Parts
Bias-T rackmount stud front
with:
●
M5 HEX nut
●
M5 screw stud press fitted
on 1U panel
Bias-T rackmount stud rear
Parts
R&S ESCU-Z01 Bias Unit with:
●
M3x6 screws
Installing the rackmount kit
Quantity
1 piece
●
2 pieces
●
2 pieces
1 piece
Quantity
1 piece
●
4 pieces
12
Publicité
