Télécharger Imprimer la page

Bosch DKE 995 P Mode D'emploi Et Notice De Montage page 18

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 29
Operating procedure
The most effective method of removing
vapours produced during cooking is to:
Switch the ventilator ON
as soon as you begin cooking.
Switch the ventilator OFF
a few minutes after you have finished
cooking.
Light
Fan OFF
Reduce fan speed
Acoustic signal:
When a button is pressed, this is verified
by an acoustic signal.
Switching off the acoustic signal:
Simultaneously press buttons 0 and +
until a signal is emitted after approx. 3
seconds.
Switching on the acoustic signal:
Repeat the process.
Switching the fan ON
Press the + button.
Setting the required fan speed:
Press the + button.
The fan speed is increased by one step.
Press the – button.
The fan speed is reduced by one step.
Switching the fan OFF:
Press the 0 button.
{
The displayed
goes out shortly
afterwards.
Or:
Keep pressing the – button until the fan
switches off.
{
The displayed
goes out shortly
afterwards.
18
Display for
Fan follow-
fan setting
on
Fan ON and
increase
speed
Intensive setting:
Maximum power is obtained at the
intensive setting. It is only required for short
intervals.
Keep pressing the + button until a
appears in the display.
If the intensive setting is not cancelled by
hand, the fan will automatically switch
}
back to step
after 10 minutes.
Fan follow-on:
Press the
button.
The fan continues to run at step
minutes, and at the same time a dot
flashes in the display. After this period
the fan switches off automatically.
Lighting:
a
Briefly press the
light on and off.
The light can be switched on at any
time, even though the fan is switched off.
Adjusting the brightness:
a
Hold down the
button until the
desired brightness is obtained.
Switching on the light automatically, e.g.
via a timer:
Fan and light must be switched off.
Switching on:
Simultaneously press the – and
buttons.
After approx. 3 seconds the light
switches on to acknowledge the setting.
Switching off:
Repeat the process with the light switched
on.
After approx. 3 seconds the light
switches off to acknowledge the setting.
ç
|
for 10
button to switch the
!

Publicité

loading