Publicité
Les langues disponibles
Les langues disponibles
G
B
5. Preliminary checks
Preliminary checks must be executed by qualified personnel only, paying the maximum attention . The correct wiring of the motor is very important for a correct functioning of the automation.
After having checked the wirings and verified that there
are no short circuits, unlock the motor and power the
system.
Press the cabled button OPEN.
Press the cable button close.
NOTE - when the control unit will be activated, it emits 2 beeps to signal the correct start up.
6. Learning a transmitter through the "RADIO LEARN" key of the control unit
STOP THE AUTOMATION
ch: A
ch: B
NOTE:
DIP 4 OFF => With a SUN 4CH remote control it is possible to associate the C and D keys to another R-CRX control unit (2 control units can be managed in total)
DIP 1-2-4 ON => With a SUN 4CH remote control it is possible to associate the A-B-C-D keys to 4 different control units (4 control units can be managed in total)
ch: C
ch: A
ch: B
ch: D
➡
➡
➡
➡
To enable the learing procedure press
and release the "RADIO LEARN" button.
The buzzer emits long beeps each
second (for 20 s)
YES
⬇
While buzzer emits long beeps each
second, press and release the "A"
button of the transmitter.
The buzzer emits two long and two
short beeps.
YES
⬇
DIP 4 OFF: The 2 buttons "A" and "B" of the remote control are memorized simultaneously and the procedure is finished.
DIP 1-2-4 ON: Only the button pressed on the remote control is memorized and the procedure is finished.
Repeat the procedure if you wish to learn a new transmitter.
Check the status of the signalling LED "photo", "stop" considering that all the inputs normally
closed must have the correspondent led lighted.
• The automation opens. Correct functioning.
• The automation closes => reverse the connections between the clamp of the interested motor.
• The automation closes. Correct functioning.
• The automation closes => reverse the connections between the clamp of the interested motor.
➡
NO
Check that the automation is still.
➡
If the buzzer emits a long bip and two short ones, the transmitter
was already been memorized.
NO
If the buzzer does not make any signal verify that the transmitter
works and belongs to the SUN Series and that the battery is
charged or repeat the procedure with another transmitter.
20
Publicité
