INSTALLATION
The ice machine is supplied with a power cord. Do not
remove the grounding pin from the cord's plug. Do not use
extension cords. Follow all codes. Connect the machine so
its own 115v, 15amp circuit.
1. If the electrical outlet for the ice maker is behind the unit,
plug it into the unit.
2. Position the unit in the installation opening.
3. Turn on the water supply. Make sure that the icemaker is
plugged in and the power is on.
All manuals and user guides at all-guides.com
Installation Instructions
4. Slide the unit into the installation opening, paying special
attention to water supply and drain connections. Do not
kink!
5. Pour a couple of quarts of water into the ice storage
bin; on drain pump equipped machines the drain pump
should start and water should pump out. Check for leaks.
6. Replace the service access panel.
7. Level the unit as needed. There are Leg Caps in the
hardware packet that can snap onto the leveling legs if
they are going to show when the unit is level.
17