Publicité
Liens rapides
Publicité
Sommaire des Matières pour Peavey UH-6
- Page 1 Wireless Microphone UH-6(TRANSMITTER) Operating Manual www.peavey.com...
- Page 2 Ce symbole est utilisé dans ce manuel pour indiquer à l’utilisateur la présence d’une tension dangereuse PRECAUCION: Para disminuír el riesgo de descarga eléctrica, no abra la cubierta. No hay piezas útiles l’appareil à un réparateur Peavey agréé. pouvant être d’amplitude suffisante pour constituer un risque de choc électrique.
- Page 3 IMPORTANT SAFETY INSTRUCTIONS WARNING: When using electrical products, basic cautions should always be followed, including the following: Read these instructions. Keep these instructions. Heed all warnings. Follow all instructions. Do not use this apparatus near water. Clean only with a dry cloth. Do not block any of the ventilation openings.
- Page 4 INSTRUCCIONES IMPORTANTES PARA SU SEGURIDAD CUIDADO: Cuando use productos electrónicos, debe tomar precauciones básicas, incluyendo las siguientes: Lea estas instrucciones. Guarde estas instrucciones. Haga caso de todos los consejos. Siga todas las instrucciones. No usar este aparato cerca del agua. Limpiar solamente con una tela seca.
- Page 5 INSTRUCTIONS IMPORTANTES DE SECURITE ATTENTION: L’utilisation de tout appareil électrique doit être soumise aux precautions d’usage incluant: Lire ces instructions. Gardez ce manuel pour de futures références. Prétez attention aux messages de précautions de ce manuel. Suivez ces instructions. N’utilisez pas cette unité proche de plans d’eau. N’utilisez qu’un tissu sec pour le nettoyage de votre unité.
- Page 6 ThisdevicecomplieswithPart15oftheFCCrules.Operationissubjecttothefollowing twoconditions:(1)thisdevicemaynotcauseharmfulinterference,and(2)thisdevicemust accept any interference received, that may cause undesired operation. Warning:ChangesormodificationstotheequipmentnotapprovedbyPeaveyElectronics Corp. can void the user’s authority to use the equipment. Note - This equipment has been tested and found to comply with the limits for a Class B digitaldevice,pursuanttoPart15oftheFCCRules.Theselimitsaredesignedtoprovide...
- Page 7 ENGLISH INTRODUCTION Please read this manual thoroughly for correct operation and optimal performance. 16 Channel Dual Receiver PLL Wireless Receiver Features ® FRONT PANEL (1) Power switch (2) Infrared(IR) port: Broadcasts IR signal to transmitter. (3) Channel indicator: To display system’s receiving channel. (4) DIV indicator: Antenna receiver status indicator LED.
- Page 8 16 Channel Dual Receiver PLL Wireless Receiver Features ® CH 2 CH 1 ANT A UNBALANCED AUDIO OUT OUTPUT BACK PANEL (9) Antenna connectors (10) Balanced out Jack: XLR connector provides balanced audio output signal from this jack to the amplifier. (11) Volume adjustment knob: Adjusts the volume level of the AUDIO OUT.
- Page 9 Green Ready Flashing green Controls locked Amber Mute on Flashing red IR transmitter in process Glowing red Battery power low Pulsing red on startup Batteries dead(transmitter cannot be turned on until batteries are changed) Pulsing red after synchronization Transmitter and receiver incompatible CHANGING BATTERIES •...
- Page 10 16 Channel Dual Receiver Body Pack Transmitter ® Green Ready Flashing green Controls locked Amber Mute on Flashing red IR transmitter in process Glowing red Battery power low Pulsing red on startup Batteries dead(transmitter cannot be turned on until batteries are changed) Pulsing red after synchronization...
- Page 11 16 Channel Dual Receiver Body Pack Transmitter ® BODYPACK TRANSMITTER CHANGING BATTERIES • Expected life for alkaline batteries is approximately 8 hours. • When the transmitter light glows red, the batteries should be replaced immediately, as shown. When the Transmitter is not in use: Make sure the microphone is turned off.
- Page 12 16 Channel Dual Receiver Body Pack Sync Function ® AUTOMATIC TRANSMITTER SETUP Open the body pack transmitter battery compartment to display the infrared(SYNC) port. With the transmitter SYNC port exposed to the receiver, press SYNC When the receiver ready light glows, the system is ready for use. Close the body pack transmitter battery compartment.
- Page 13 SPECIFICATIONS SYSTEM FREQUENCY Audio Frequency Response Minimum: 50 Hz Maximum: 18 KHz +/-3 dB (Overall system frequency depends on microphone element) Total Harmonic Distortion 0.8%, typical Ref.+/-30 KHz deviation,1 KHz tone >100 dB A-weighted Dynamic Range Working Range 100 m (300 ft.) Oscillation Type Microprocessor controlled PLL Synthesized...
- Page 14 What Peavey Will Do We will repair or replace (at Peavey’s discretion) products covered by Warranty at no charge for labor or materials. If the product or component must be shipped to Peavey for Warranty service, the consumer must pay initial shipping charges. If the repairs are covered by Warranty, Peavey will pay the return shipping charges.
- Page 16 Wireless Microphone / PV® 16 Channel Dual Receiver PLL Handheld Transmitter IC Statement This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of the device.
- Page 17 Features and specifications are subject to change without notice. PeaveyElectronicsCorporation•5022HartleyPeaveyDrive•Meridian•MS•39305 (601)483-5365•FAX(601)486-1278•www.peavey.com•©2013•EX000172...