Publicité
Please follow these instructions carefully to ensure safe and satisfactory use of this
product. Choose a location where the product is to be displayed. Take all the
components out of the carton for assembly. Ensure the product is placed on a flat,
level surface.
Step 1: Insert two angled tubes (Part A) into both ends of an arched tube (Part B).
And then tighten them with a screw (Part G) (screwdriver not provided) (See figure
1). Repeat this step to make 3 same parts.
Figure 1
Step 2: Insert a male cross brace (Part E-1) into a female cross brace (Part E-2),
and push into position. (See figure 2). Repeat to make other 6 set cross braces.
（Part E-1 set cross brace）
Figure 2
Female Cross
Braces: E-2
Step 3: Fix one assembled cross brace（Part E）on the top of 3 assembled
arched parts by 3 Sure-clips (Part F). 3 assembled arched parts should be
assembled at two sides of the cross brace and middle. (See figure 3)
06
Assembly：
Male Cross
Braces: E-1
Cross Support
Arch
cross braces
Sure-clips
Arch
Remark: When using a sure-clip, make sure the cross brace should always be on
the outside of the trellis and that the curved part of the sure-clips will always be
facing towards the inside of the trellis. (See figure 4)
Figure 4
The curved part of the
Sure-Clip will always be
facing towards the inside
of the Trellis.
Instructions of Sure-clips: Open the looped end of the Sure-clip and cross the cross
brace and the Arched parts and then around back to the cross brace. (See figure 5)
Note: This may take some extra strength as the Sure-clip is made to be tight.
Figure 5
cross braces
Sure-clips
Arch
07
Publicité
