Hitachi ULTRAVISION C50M6 Guide Du Propriétaire page 13

Remote control
HOW TO INSTALL BATTERIES
1. Open the battery compartment cover.
2. Install two "AAA" batteries (supplied).
3. Replace the battery compartment cover
BATTERY PRECAUTIONS
These precautions should be followed when using batteries in this device:
• The batteries may last approximately one year depending on how much the remote control
is used. Replace batteries when the remote operation becomes erratic.
• Use only the size and type of batteries specified.
• Be sure to follow the correct polarity when installing the batteries as indicated in the
battery compartment. Reversed batteries may cause damage to the device.
• Do not mix different types of batteries together (e.g. Alkaline, Carbon-zinc or
Rechargeable) or old batteries with fresh ones.
• If the device is not to be used for a long period of time, remove the batteries to prevent
damage or injury from possible battery leakage.
• Do not try to recharge batteries not intended to be recharged; they can overheat and
rupture. (Follow battery manufacturer's directions.)
• Please use caution when inserting batteries to avoid battery damage. If the spring
terminal in the remote control remains in contact with a side of a damaged battery it can
cause a short circuit. Never use damaged batteries as they can become very hot and are
dangerous.
• Never expose batteries (battery pack or batteries installed) to excessive heat such as
sunshine, fire or the like.
(continued)
EN13