Publicité
Les langues disponibles
Les langues disponibles
English
nOTE: Continuous use in variable speed range is not
recommended. It may damage the switch and should
be avoided.
nOTE: The first time the tool is run after changing the
direction of rotation, you may hear a click on start up. This is
normal and does not indicate a problem.
Worklight (Fig. A)
The worklight
10
is activated when the trigger switch is
depressed, and will stay illuminated for 20 seconds provided
the trigger isn't depressed or the motor isnt running.
PushStart mode does turn the LED on.
nOTE: The worklight is for lighting the immediate work
surface and is not intended to be used as a flashlight.
Screwdriving (Fig. A)
For best results, hold the screwgun directly inline with the
fastener. The screwgun is equipped with four driving modes
(refer to Mode Selection).
To drive the fastener, place it on the bit, press the variable
speed switch and push the fastener into the workpiece with
a smooth, continuous motion. When the fastener is seated,
the clutch will disengage automatically.
Before driving screw:
1. Install bit tip in bit holder.
nOTE: The tool bit tip should match the head of screw
you are driving.
2. Adjust depth locator
3. Check for correct direction
4. Place screw on bit.
5. Contact work surface applying forward pressure to drive
screw until depth locator contacts the work surface.
Screwgun will ratchet automatically disengaging bit from
screw.
6. This depth sensitive screwgun is suitable for driving
drywall screws.
For this Depth Sensitive Clutch Please
Remember:
•
The bit will not turn until pressure is applied to the unit.
Push to engage.
•
Trigger switch will not depress unless tool is in either
forward or reverse position.
Mode Selection (Fig. G)
WARNING: Motor must be off for any mode change
to take effect.
The DCF630 is equipped with a mode selector button
used to cycle through the four screwdriving modes.
10
Mode
Trigger Mode
(high speed)
LED 2
illuminated
19
Trigger Mode
(low speed)
LED 1
illuminated
18
Pushstart
LED 2
19
and
LED 3
20
illuminated
lock‑On
All 3 LEDs illuminated
MAINTENANCE
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start‑up can cause injury.
Your D
WALT power tool has been designed to operate
e
over a long period of time with a minimum of maintenance.
8
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.
Cleaning
WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the risk
of eye injury, always wear ANSI Z87.1 approved eye
protection when performing this procedure.
WARNING: Never use solvents or other harsh
chemicals for cleaning the non‑metallic parts of the
tool. These chemicals may weaken the plastic materials
Application
When the variable trigger is
pulled, the motor will spin in the
selected direction, with a speed
proportional to the amount of
trigger pull.
When the variable trigger is
pulled, the motor will spin in the
selected direction, with a speed
proportional to the amount
of trigger pull, with a lower
maximum speed.
When the tool is pushed against
the workpiece, the motor will
start automatically in the selected
direction at maximum speed.
WARning: In this mode, the
trigger wont turn the motor
on, however it will turn on the
LED light.
Fully pulling and releasing
the trigger will lock the tool
on, with the motor running at
maximum speed.
Fully pulling the trigger a second
time will turn off the motor.
Publicité
