Publicité
To install bagger com po nents to tractor
1
1. Dis charge Chute
2. 3/8 Nut
3. Flat Washer
•
Remove discharge chute from rear of tractor. Unhook the
two (2) straps and pull chute out and away from tractor.
•
Remove the two (2) 3/8 nuts and fl at washers from the
bolts at the tractor back plate.
3
2
1
1. 3/8 Lock nut
2. Flat Wash er
3. Support Tube
•
Using the nuts and fl at washers removed from tractor
back plate, install the bagger support tube to the back
plate as shown. Tighten securely.
2
3
23
3
1. Support Bracket
2. 3/8 Carriage Bolt
3. 3/8 Lock Nut
4. 3/8 x 63,5mm Hex Bolt
5. 10,3mm (13/32") flat
washer
•
Install the two upper support brack ets through the back
plate and to the chas sis, using the 10 x 19 mm (3/8"x3/4")
carriage bolts and locknuts sup plied. Tight en se cure ly.
•
Assemble both support brackets to the outside of the
baggger support tube using two each 3/8 x 63,5mm hex
bolts13/32" I.D. fl at washers and 3/8 locknuts from parts
bag. Tight en securely.
2
1. Hook
2. Discharge Chute
3. Back plate slot
•
Replace discharge chute into rear opening of tractor.
Secure the chute with the two hook straps.
NOTE: The strap hook must go through the discharge chute
only. Do not allow the hook to enter the slot in the tractor
back plate. This will allow the dis charge chute to fl oat with the
mower deck when moving on uneven terrain.
2
3
1
5
4
2
1
3
Publicité
