Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY INSTRUCTIONS
Warning: During the assembly procedure, nuts and bolts should be hand tightened only. Once
assembly is complete, nuts and bolts must be fully tightened.
1. Attach two front wheels (#19) to front beam (#20) using nuts (#17) and lock washers (#18).
2. Attach front beam assembly (#20) to middle beam (#16) using bolts (#9), nuts (#11) and lock
washers (#10).
3. Attach main post (#5) to rear beam (#14) using bolts (#9), nuts (#11) and lock washers (#10).
4. Insert middle beam assembly (#16) to the tube of main post (#5) and secure it with bolt (#15).
5. Insert rotating plate (#3) through the tube at the top of the main post. Rotate the plate till one of
the holes in the inner tube is aligned with a hole in the outer tube and insert the ringed pin (#4).
6. Insert the handle (#1) through the hole in the rotating plate tube which protrudes from the top off
the main post.
7. Attach four fingers (#2) to the rotating head (#3) using bolts (#8), flat washers (#6) and nuts (#7).
8. Check all bolts for tightness before operating.
EXPLODED DRAWING
N°
Description
1
Handle
2
Finger
3
Rotating Plate
4
Pin
5
Main Post
6
Flat Washer Ø14
7
Nut M14
8
Bolt M14x65
9
Bolt M10x75
10 Lock Washer Ø10
11 Nut M10
12 3" Rigid Wheel
13 Split Pin
14 Rear Beam
15 Bolt M12x25
16 Middle Beam
17 Nut M12
18 Lock Washer 012
19 3" Swivel Caster
20 Front Beam
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
QTY
1
4
1
1
1
10
4
4
4
4
4
2
2
1
1
1
2
2
2
1
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicité
