Ermax SUP010 Notice De Montage page 2

1074, Avenue des Carrières – Z.A la Plaine du Caire III
13830 ROQUEFORT LA BEDOULE – FRANCE
www.ermax.fr - E-Mail : accueil@ermax.fr
Fitting kit
- 4 screws FHC Ø4x20
- 4 screws FHC Ø5x20
- 2 screws FHC Ø6x20
- 2 screws FHC Ø8x20
- 4 nuts Ø4
- 4 nuts Ø5
Fitting instructions
- Place the SUP10 as shown on the picture above and then fit it on the top plate for your motorcycle.
- Adjust incline for the good visibility of your number plate and then block screws.
- Connect indicators and plate lighting, and position the reflector (the original one or the one supplied in the
fitting kit).
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* The mentioned label of motorbikes's manufacturers are indicated exclusively as a reference to Ermax accessories.
* Care to excessive clampings which may damage or break our plastic accessories and aluminium screws.
- 2 nuts Ø6
- 2 nuts Ø8
- 1 plate lighting EDP05
- 1 reflector support SDC03
- 2 blinkers supports
- 1 reflector
For a compliant mounting, refer to enclosed instructions.
FITTING INSTRUCTIONS
« CAUTION »
ERMAX SUP010
ADAPTABLE ON PLATINE
Estimated mounting time : 60 mn