Pullman-Holt 102DA Instructions D'utilisation Et D'entretien

Model 102DA
Wet/Dry Drum Adapter
This vacuum cleaner is a high quality, precision made
product. All parts used in the manufacturing of this
vacuum cleaner have passed rigid quality control
standards prior to assembly and an "each unit" fi nal
inspection prior to packaging is your assurance of
proper assembly. This vacuum cleaner was protectively
packed to prevent possible damage in transit. Should
damage occur, please notify the transporting carrier
immediately for loss and/or claim.
MOTOR:
The suction head of this vacuum cleaner is
equipped with a 2 stage, 11.1 amp, 2HP by-pass
motor, developing 105" waterlift and 110 CFM.
When removing the motor head, care in handling
is essential. Dropping, banging or other abuse
may result in poor vacuum seal and a loss in
suction power and will invalidate your warranty.
CAUTION
Do not use this vacuum to pick up hazardous
materials without HEPA fi lter being installed.
CAUTION
Never lubricate the vacuum cleaner motor. The
motor bearings are permanently sealed. This
vacuum is intended for indoor or outdoor use
and for wet pickup, but it is not intended to be
exposed to rain.
Operation & Care Instructions
Save For Future Reference
IMPORTANT SAFEGUARDS
EXTENSION CORDS:
Machines that have 3 wire cords requiring
grounding must only be used with extension
cords that have 3-prong grounding type plugs
and 3-pole receptacles.
To determine the minimum wire size required,
refer to the chart below:
Minimum Wire Size (AWG) of Extension Cord
Nameplate
Rating-Amps
25 50
0-10.0
18 18
10.1-13.0
16 16
13.1-15.0
12 12
Before using an extension cord, inspect it for
loose or exposed wires, damaged insulation and
defective fi tting.
NOTE: Warranty claims will be honored ONLY if
handled by an authorized Pullman-Holt Service
Center unless other prior arrangements have been
made with the Pullman-Holt Service Department.
Total Extension Cord Length (Feet)
75 100 125 150
16 16 14 14
14 14 14 12
12 12 12 12
175 200
12 12
12 12
12 -