MODEL
AU-A1ZBRC
VOLTAGE (V)
3 V DC
BATTERY TYPE
CR2450/DL2450 Lithium Battery
POWER CONSUMPTION
19.8 mW
BATTERY LIFE
Estimated 2 Years
MAX. OUTPUT RF POWER
8.5 dBm/mW
MAX. NUMBER OF DEVICES
20 Zigbee Devices
OPERATING RANGE
30 M
MAX. AMBIENT TEMPERATURE LIMITS 40°C
IP RATING
IP20
PROTOCOL
Zigbee 3.0
FREQUENCY BAND
2.40 Ghz - 2.483 Ghz
• There are no restrictions of use.
• Hereby, Aurora Limited declares that the radio equipment type
AU-A1ZBRC is in compliance with Directive 2014/53/EU. The full text of the EU
declaration of conformity is available at the following internet address:
www.auroralighting.com/ProductDetail/AU-A1ZBRC
CAUTION PRODUCT CONTAINS LITHIUM METAL BATTERY:
• KEEP OUT OF REACH OF CHILDREN
• Keep in original package until ready to use.
• Risk of fire and burns
• Do not recharge
• Never put battery in mouth or swallow
• Dispose of used battery promptly
• If ingested, immediately seek medical attention.
USING THE APP TO CONNECT THE REMOTE TO THE HUB
1. Follow instructions on the App to pair the Hub with the AONE remote.
2. Put the module into pairing mode by following the diagram:
The Aone remote will show a constant red indicator that confirms it has
successfully paired with the HUB.
The Aone remote can then be set up using the app.
MOUNTING WALL BRACKET
2
1
IMPORTANT: Ensure it is safe to
screw to the wall
Attach to wall with screws or adhesive
Unclip the back
pad provided
REPLACING THE BATTERY
1
PAIRING DEVICE
1
2
•
Follow instructions on
the App to pair the Hub
with the AOne remote
through the devices tab
pressing the + in the
top right corner.
•
Put the module into
pairing mode by
following points 2-5.
www.auroralighting.com
3
Clip on
2
Carefully unscrew
battery cover
3
Press and hold for 3
seconds, then release
the button
Pairing button
4
Remote is held in
place by magnets
3
4
A periodic flash will
A constant red light
confirm remote is
stays on for 10 seconds
searching for the hub
indicating it has paired
successfully
Document Version: AU-A1ZBRC_V3_18
On/Off
Dim Up
Dim Down
50% Dim