Vonyx VSA Serie Manuel D'instructions page 4

UNPACKING INSTRUCTION
CAUTION! Carefully unpack the box upon receipt. Check the contents to ensure that all parts are present and have been
received in good condition. Notify the shipper immediately and retain packaging material if any parts appear damaged from
shipping or the package itself shows signs of mishandling. Save the package and all packaging materials. If the product must be
returned, it is important that the product is returned in the original factory box and packaging.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
The label on the back/under side of the product indicates the mains voltage to which it must be connected. Check that the mains
voltage corresponds to this. Any other voltage than the one indicated may cause irreparable damage to the unit. The unit must
also be connected directly to the mains voltage and no dimmer or adjustable power supply may be used.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
REAR PANEL
1. MIC 1 VOLUME LEVEL
Controls the microphone input volume
2. MIC 2 VOLUME LEVEL
Controls microphone input volume
3. LINE VOLUME LEVEL
Controls the line input volume
4. GUITAR
Two 6.3mm jack inputs for connecting guitars
5. RCA LINE IN
RCA connectors for line signal input
6. AUX IN
Auxiliary 3.5mm input connector
7. MIC 1 IN
This connector can either take a 6.3mm Jack balanced or an
XLR balanced cabled microphone
8. MIC 2 IN
This connector can either take a 6.3mm Jack balanced or an
XLR balanced cabled microphone
9. XLR LINE IN
XLR connector for line signal input
10. XLR LINE OUT
XLR connector for line signal output
11. MASTER VOLUME
This knob controls the master volume
12. TREBLE CONTROL
Adjust the high frequencies of the corresponding
channel
13. BASS CONTROL
Adjust the low frequencies of the corresponding channel
14. AC IN AND FUSE HOLDER
Socket for plugging in the supplied power cord. For instructions on how to change the fuse, see "REPLACING THE FUSE"
15. POWER SWITCH
Turn the device ON or OFF
REPLACING THE FUSE
If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.
4