Vonyx Fuzzix PLB20S Manuel D'instructions page 3

Do not attempt to make any repairs yourself. This would invalid your warranty. Do not make any changes to the product. This would also
invalid your warranty. The warranty is not applicable in case of accidents or damages caused by inappropriate use or disrespect of the
warnings contained in this manual. Fuzzix cannot be held responsible for personal injuries caused by a disrespect of the safety
recommendations and warnings. This is also applicable to all damages in whatever form.
UNPACKING INSTRUCTION
CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also
be directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
OPERATING INSTRUCTIONS
Place the lamp on a flat surface and make sure that there are no flammable materials near the lamp.
Connect the plug of the adapter to the plasma bulb and then plug the adapter into a wall socket.
The selector switch has 3 positions: OFF / AUDIO / ON
The plasma ball contains a gas mixture. When the switch is set to "ON", the product base produces high-frequency
electromagnetic waves, which transform the gases into plasma - an ionised or electrically charged gas.
The ions produced emit energy that appears as coloured light filaments. The plasma ball reacts to your touch, with the light
beams following your fingers when you touch the ball. You may feel a slight tingling sensation when your hand comes close to
the glass and touches it. This is caused by the vibrations on the glass ball when the electrons hit the surface of the ball.
3