Publicité
Les langues disponibles
Les langues disponibles
8
8A
8C
8C
8 SLIDE BAR PREPARATION
Remove Posts (8A) from Slide Bar (8B). Remove Decorative Button (8C) from Posts (8A).
9
9B
9A
9C
9 BOTTOM POST AND BAR INSTALLATION
Orient Bottom Post (9A) so that the Support Socket (9B) faces up. Insert Mounting Screw
(9C) through the hole on Bottom Post (9A) and Back Flange (9D) and tighten until is flush
with the wall. Do Not Over Tighten! Insert one end of Bar (9E) into Support Socket (9B).
10
10A
10B
10 TOP POST AND BAR INSTALLATION
Insert the Top Post (10A) into the other end of the Bar (10B). Insert Mounting Screw (10C)
through the hole on Top Post (10A) and Back Flange (10D) and tighten until is flush with
the wall. Do Not Over Tighten!
8B
8A
9D
9E
9B
10D
10A
10C
ENGLISH
11
11A
11 BUTTON INSTALLATION
Insert Decorative Buttons (11A) into Posts (11B). Apply with a small bead of silicone around
outer edge where post meets wall (11C).
12
12B
12D
12 DROP ELBOW & HOSE INSTALLATION
Apply PTFE plumbers tape on both ends of Pipe Niple (12A) (not included). Screw Pipe
Niple (12A) into the elbow inside the wall. The Pipe Niple (12A) is to project
the finished wall. Screw Drop Elbow (12B) onto Pipe Niple (12A) and tighten until Drop
Elbow is properly positioned and flush to the finished wall. Connect Hose (12C) into the Drop
Elbow Outlet (12D) by turning Metal Hose Fitting (12E).
3
11B
11C
11A
11C
11B
12A
12E
12C
1
/
" -
3
/
"
4
8
1
"-
3
" from
/
/
4
8
Publicité
