AQUA FORTE Midi Power UV-C T5 - 40/75 WATT Mode D'emploi page 5

quartz glass (M) and tighten the screw cap (N) finger-tight on the unit.
4. Start the pump and check the flow of the system and that it is not leaking. Then
check the seals (P) for correct positioning both at the connections and the quartz
glass (see drawing 2).
5. Plug the power lead of the Midi Power UV-C T5 device into an earthed electrical
socket with an earth leakage switch. Check that the lamp lights up; this can be seen
through the transparent attachments on the device.
6. The device is switched off by removing the plug from the electrical socket.
7. Make sure there is enough room left (+/- 1 mtr.) to remove the lamp (K)/quartz glass
(M) for replacement and/or maintenance.
Dismantling/Maintenance (drawing 2)
During maintenance/dismantling always disconnect electrical current. The device needs
to be cleaned twice a year. If algae or lime scale forms on the quartz glass tube (M)
containing the lamp, it must be cleaned. The special lamp must be replaced after 9,000
hours. Clean the stainless steel interior with a soft brush.
1. Unscrew the three-part couplings (I) and allow the water to flow out of the device.
2. Twist the cap (N) containing the lamp off the device and replace the special lamp (K)
if needed. Please handle with care as these are very delicate parts.
3. Carefully remove the quartz glass (M) with a large flat screwdriver (see drawing 3).
Never force it!
4. Clean the quartz glass with an appropriate solution. Always use a soft cloth to clean
the glass to prevent scratches.
5. When replacing the quartz glass in the housing make sure that it is placed on the
seals (P) correctly and carefully slide the end of the quartz glass into the receiving
guide (Q) (see drawing 4)
If the housing or the electrical section must be replaced then the earthing should
first be disconnected from the housing. When assembling a new housing or electrical
section then please read Installation and Dismantling first. Make sure that you keep
the various bits of the earthing properly. These are not supplied with a new housing
or electrical section. If there is any doubt about the connection, consult a certified
electrician.
Guarantee conditions
The product is guaranteed for 24 months from the day of sale against factory production
faults. The lamp, the quartz glass and the starter are not covered by the guarantee.
Complaints relating to guarantees can only be dealt with if the product is returned
postage paid and is accompanied with a valid proof of purchase. Guarantee repairs
may only be done by the supplier. We will not honour guarantee claims resulting from
installation or operation mistakes. Defects arising from poor maintenance are also not
covered by the guarantee. The supplier is in no way responsible for damages resulting
from wrong use of the product. The supplier is not liable for any consequential damage
resulting from failure of the equipment unit. Complaints due to transport damage can
only be accepted if the damage is determined and confirmed by the shipping agent,
railway company or post office upon delivery of the goods. Only then it will be possible
to assert claims against the shipping agent, railway company or post office.
Technical specifications Midi Power UV-C T5
TUV 4P-SE T5
UV-C (%) after 9,000 hours
Pond content (L.)
Max. flow through
Max. pressure
Recommended flow
40 Watt
40 Watt
80%
30.000 L
15 m /h
3
2 bar
11.000 L/h 16.000 L/h
AQUA FORTE MIDI POWER UV-C • 5
75 Watt
75 Watt
80%
60.000 L
20 m /h
3
2 bar