Publicité
Les langues disponibles
Les langues disponibles
1. Remove the grease filters.
2. Reach within the unit and push out the lamp housing to-
wards you. See Fig. 1 on previous page.
3. Using a small, flat-head screw driver pop off the glass
plate. See Fig. 2 above.
4. Remove the burnt out 2-pronged 20 watt Halogen bulb.
Replace with a new 20 watt Halogen bulb. Wipe the new bulb
with a clean cloth before replacing the cover.
5. Caution: the lights are designed for 20 watt Halogen bulbs
only. Replacing with high wattage bulbs can result in
damage to the rangehood or fire and not recommended
6. Replace lamp cover and press lamp housing back into
place.
CLEANING & MAINTENANCE
The mesh filters are intended to trap residue and grease
produced during cooking process. To ensure optimal perfor-
mance, appearance, and a sanitary cooking environment,
clean the filters, fan and grease laden surfaces regularly. Use
only a clean cloth and mild detergent solution on stainless
steel and painted surfaces. Do not use corrosive or abrasive
cleaning agents or steel wool or scouring pads as these will
scratch the surface. Do not use cleaning products that use
chlorine bleach or orange cleaners.
The grease filters, bottom panel surrounding the grease filters,
and the blower should be cleaned frequently. When washing
by hand use warm soapy (mild detergent) water. The grease
filter and blower wheels are dishwasher safe.
The motor is permanently lubricated and never needs oiling. If
the motor bearings make unusual or excessive noise, call for
service at 1-800-263-2629.
Hood Cleaning
Stainless steel is one of the easiest materials to keep
clean. Occasional care will help preserve its fine appearance.
Fig. 2
Cleaning tips:
Hot water with soap or detergent is all that is usually needed.
Follow all cleaning with rinsing with clear water. Wipe dry with
a clean, soft cloth to avoid water marks.
For discolorations or deposits that persist, use a non-
scratching household cleanser or stainless steel polishing
powder with a little water and a soft cloth.
For stubborn cases, use a plastic scouring pad or soft bristle
brush together with cleaning solution and water. Rub lightly
in direction of polishing lines or "grain" of the stainless finish.
Avoid using too much pressure which may alter the surface.
DO NOT allow deposits to remain for long periods of time.
DO NOT use ordinary steel wool or steel brushes. Small bits
of steel may adhere to the surface causing rust.
DO NOT allow salt solutions, disinfectants, bleaches, or
cleaning compounds to remain in contact with stainless steel
for extended periods.
Many of these compounds contain chemicals which may be
harmful.
Rinse with water after exposure and wipe dry with a clean
cloth.
Painted surfaces should be cleaned with warm water and mild
detergent only.
6
Publicité
