Polar GH337 Mode D'emploi page 5

Cleaning, Care & Maintenance
• Switch off and disconnect from the power supply before cleaning.
• Clean the interior of the appliance as often as possible.
• Do not use abrasive cleaning agents. These can leave harmful residues.
• Clean the door seal with water only.
• Always wipe dry after cleaning.
• Do not allow water used in cleaning to run through the drain hole into the evaporation pan.
• Take care when cleaning the rear of the appliance. Sharp edges can cut.
Condensation and ice will form with frequent and prolonged opening of the doors.
Operating outside of the recommend temperature range and placing next to a heat source will also
increase the amount of ice and condensation.
Excessive ice will result in longer running times that will increase energy consumption and increase the
deterioration of components.
Cleaning the Condenser
Periodically cleaning the condenser can extend the life of the appliance.
Defrost
When any ice built-up reaches 5mm thick, a manual defrost process is required. To do this switch the
freezer off at the power supply. Then, manually defrost the appliance. Never use sharp objects for
scraping.
Troubleshooting
A qualified technician must carry out repairs if required.
Fault
The appliance is The unit is not switched on
not working
Plug or lead is damaged
Fuse in the plug has blown
Mains power supply fault
The appliance Too much ice on the evaporator Defrost the appliance
turns on, but the
Condenser blocked with dust
temperature is too
Lid not shut properly
high/low
Appliance is located near a
heat source or air flow to the
condenser is being interrupted
Ambient temperature is too
high
Appliance is overloaded
The appliance is The appliance is not properly
leaking water levelled
The appliance is Loose nut/screw
unusually loud
The appliance not installed in a
level or stable position
GH337_GH339_ML_A5_v1_20211129.indb 5 GH337_GH339_ML_A5_v1_20211129.indb 5
Probable Cause Solution
Check the unit is plugged in correctly and switched
on
Replace Plug or lead
Replace the fuse
Check mains power supply
Clean the condenser
Check lid is shut and seals are not damaged
Move the refrigerator to a more suitable location
Increase ventilation or move appliance to a cooler
position
Reduce the amount of food stored in the appliance
Adjust the screw feet to level the appliance (if
applicable)
Check and tighten all nuts and screws
Check installation position and change if necessary
EN
5
2022/11/29 11:25 2022/11/29 11:25