Publicité
1. Prior to installation, install the mounting plate on the
junction box with mounting screws. Drive screws
completely to the end of the junction box.
2. Connect supply wires to wires on fixture with wire
nuts. Connect white to white, black to black and copper
wire to copper wire as grounding connection.
3. Completing the installation by pushing the fixture
into the mounting plate.
2 Wiring Guide
"LED driver must be installed inside junction box. See dimensions"
A. Install with Dimmer (0-10V) FOLLOW
DIMMER WIRING INSTRUCTIONS
WHITE (NEUTRAL)
SUPPLY WIRE
HOT
DIMMER WIRE
PURPLE SUPPLY
DIMMER WIRE
GRAY SUPPLY
DIMMER WIRE
GREEN/YELLOW
GROUND WIRE
FROM SUPPLY
B. Install without Dimmer
USE WIRE NUTS TO CAP OFF UNUSED
PURPLE AND GRAY DIMMER WIRES
WHITE (NEUTRAL)
SUPPLY WIRE
BLACK (HOT)
SUPPLY WIRE
GREEN/YELLOW
GROUND WIRE
FROM SUPPLY
2.25in
57mm
WHITE
FIXURE WIRE
WIRE NUTS
BLACK
FIXURE WIRE
PURPLE SUPPLY
FIXTURE+10V
OR
GRAY SUPPLY
FIXTURE+10V
GREEN/YELLOW
FIXTURE GROUND
WHITE
FIXTURE WIRE
BLACK
FIXTURE WIRE
GREEN/YELLOW
FIXTURE GROUND
Page 4 of (4)
Publicité
