Salter NO TOUCH Mode D'emploi page 8

Memory Recall button.
1. When the device is on, press once briefly on the "MEM button", then pass it again
to show the last measurement accompanied by
2. The symbol or
memory to indicate whether a person or object temperature was taken.
3. Each press of the same button recalls a previous measurement, so
the way to . Continue to press the Memory Recall button button to view the
next previously stored measurement.
4. Any new measurement will be recorded and the oldest memory deleted without
you having to do anything.
Memory Deletion
1. Under power on status, you may keep press MEM Button for more than 3 seconds
to delete all the readings.
2. You will see "--" on display and "sound four short beeps", that mean all the
memories are cleared.
3. Automatically on the 31th measurement: when the 30 memories have been used
up, any new measurement will be recorded with
deleted without you having to do anything.
All the readings will be cleared no matter record in Human mode or Object mode.
CLEANING AND DISINFECTING
Lens/ Measurement Sensor
Gently clean with an alcohol swab.
Do not use water to wash the thermometer lens directly.
Thermometer
Clean with a soft, dry cloth.
Do not use water to rinse the device.
symbol will appear with each measurement stored in
8 | GB
symbol.
then all
and the oldest memory