Publicité
Les langues disponibles
Les langues disponibles
require permits for installation and use. Some special procedures may be valid in your area.
9. While this gazebo is manufactured to withstand strong force winds through only the supplied
ground stakes, in areas subject to frequent severe weather, securing the gazebo to a deck,
concrete patio or footings should be considered.
10. Always ensure that the roof canvas is tensioned, so as to avoid water accumulation on the
roof.
11. Remove accumulated water on the roof immediately, or disassemble the gazebo in order
to avoid damages.
NOTE: The gazebo's roof and structure are not guaranteed against extreme weather
conditions (storms, high winds, etc.). If the gazebo is not dismantled for the winter, snow must
be cleaned off regularly. Any damage caused by snow accumulation is not covered by the
warranty.
Care & Maintenance:
Our steel components for garden accessories and furniture are treated with rust inhibiting paint
that protects it from rusting. However, due to the nature of steel, surface oxidation (rusting) will
occur if these protective coatings are scratched. This is not a defect and thus not covered by
the warranty.
To minimize this condition, we recommend care when assembling & handling the product to
prevent scratching the paint. Should any scratching or damage occur, we recommend
immediate touch-up with rust inhibiting paint.
Surface rust can also be easily removed with a very light application of common cooking oil. If
surface oxidation (rusting) occurs and if no measure is taken to prevent this, the oxidation may
start dripping onto deck or patio and caused damaging stains, which may be difficult to remove.
This can be prevented if the above-mentioned measures are taken to keep the product from
oxidizing.
GAZEBO ASSEMBLY INSTRUCTIONS
Our clear, easy-to-follow, step-by-step instructions will guide you through the project from start
to finish.
All you will need is a screwdriver, a hammer and two ladders of at least 8 feet (2.5 m) high (not
included).
DO NOT assemble this item alone for your safety. Four people are necessary for smooth &
safe installation.
Item identification: For ease of identification, all parts are labeled to correspond to the Step
number in which the part is used.
Have 4 or more people helping you when assembling or moving the product.
2
Publicité
