HomeTech EF423 Guide D'installation Et D'utilisation page 7

Instructions for Use
•
The appliance can be operated either by the switches located on the top right hand side of the fire
or by supplied remote control.
Manual Operation
•
The switches located at the top right hand side of the fire. The standby switch must be first switch
on.
•
Press once the button
appear to indicate that the function is ON. Press the button
the dimmer mode.
•
Press once the button
setting.
•
Press once the button
setting.
Remote Operation
•
The standby switch located at the top right hand side of the fire must be first switch on.
•
It takes some time for the receiver to respond to the transmitter. Do not PRESS the buttons more
than once within two seconds for correct operation.
•
Press once the button
effect.
•
Press once the button
setting.
•
Press once the button
setting.
•
Press the button
Safety Cut-Off
•
This appliance is fitted with a safety cut-off which will operate if the fire overheats (eg. due to
blocked air vents). For safety reasons, the fireplace will NOT automatically reset.
•
To reset the appliance, disconnect the appliance from the mains supply for at least 15 minutes.
Reconnect the supply to the mains and switch on the appliance.
No operation/ no fan.
No fire effect light.
OPERATING INSTRUCTIONS
to turn on the appliance and fire effect. A red indicator light will
for the low heat settings (750W); press twice to switch off the heat
for the high heat settings (1500W); press twice to switch off the heat
on the remote control this turns ON/OFF the appliance and fire
for the low heat settings (750W); press twice to switch off the heat
for the high heat settings (1500W); press twice to switch off the heat
to operate the dimmer mode.
SAFETY FEATURES
TROUBLESHOOTING
Symptom
for 3 seconds this will operate
Solution
Check for safety cut-off operation.
Check the bulb by replacement.