Publicité
Les langues disponibles
Les langues disponibles
A.
IMPORTANT NOTICES
CAUTION. This symbol indicates a potentially
hazardous situation, which, if not avoided, may result
in personal injury or damage to the equipment.
CAUTION
WARNING.
This symbol indicates an imminently
hazardous situation, which, if not avoided, can result in
serious injury or damage to the equipment.
WARNING
WARNING.
Read and adhere to the following. Failure to
do so may result in a risk of fire, electrical shock, and
severe or fatal injury. Warranty will be void.
WARNING
1.
Read and follow all instructions in this manual.
2.
Appropriate protection against ground faults, such as a
ground-fault circuit interrupter or GFCI, is required to be
used with this equipment. Failure to provide protection
against electrical grounding or bonding during the use of
this equipment can result in property damage, personal
injury, or death. In addition, this equipment must be
effectively grounded in compliance with all applicable
electrical codes and standards.
3.
This heater is intended to be used for commercial and
industrial indoor space heating applications.
WARNING.
Heater is not to be used in hazardous
atmospheres where flammable vapors, gases, liquids or
other combustible atmospheres are present.
WARNING
4.
Heater is to be connected and serviced only by a
qualified electrician.
5.
Installation and wiring of the heater must adhere to all
applicable codes.
6.
Disconnect heater from power supply at disconnect or
fuse box before opening enclosures or servicing heater.
IF DISCONNECT IS BEING SERVICED, verify power has
been disconnected at fuse box or main panel. Lock the
"OFF"
switch in the
(open) position and tag the switch to
prevent unexpected power application.
WARNING.
Elements get hot during operation. Contact
can cause burns.
WARNING
7.
Do not operate heater in wet and humid environments.
8.
Install and maintain clearances as per this manual.
9.
Do not operate the heater in corrosive atmospheres.
10.
Use factory replacement parts only.
11.
Maximum ambient operating temperature is 40°C
(104°F).
12.
Do not operate the heater with the louvers deformed
or damaged.
13.
If there are any questions or concerns regarding the
heater, please refer to contact information on the back
page of this manual.
14.
Follow the recommended maintenance procedures under
Section I - Heater Maintenance Instructions, page 15.
3 3
Publicité
