Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
5.4 PX.3 Manual pause - Duration
This is the time of the pause which can be utilized
by the user of the service. It can be divided into
more than one period. If other than 0, the service
automatically starts in pause mode and is
activatedat the end of the pause time established or
upon pressing the start/pause button.
For each service available a start/pause button can
be connected to the CTx. This is for activating a
service or for placing a service in pause up to the
maximum time established.
It will be used as a delayed start for
services which are not supplied with
start/pause buttons.
Fig. 24: Manual pause - Duration
5.5 PX.4 Automatic pause - Start
The automatic pause allows for the CTx service to
be interrupted for a certain amount of time. It can
be used as a warning notice for the end of service,
or for allowing time to lather in showers not
supplied with start/pause buttons.
This parameter indicates the precise moment of
activation of the automatic pause before the service
end time.
For example, if this parameter shows 30 seconds,
then the service will enter into pause mode 30
seconds before end time.
Fig. 25: Automatic pause - Start
00182-M01-02-ML - Manuale uso CTx
5.6 PX.5
Automatic pause - Duration
With the
than 0 if you wish to insert an automatic pause during
.
service
Fig. 26: Automatic Pause - Duration
Unlike the warning notice (ch. 4.8 and
4.9), the automatic pause interrupts the
service.
6
F
ACTORY SETTINGS
The default values are useful for initial testing of the
CTx and correspond to 30 seconds of service time
and 2 seconds of manual pause time. The other
times are set at 0.
From the programming menu press down
the PROG. button for 10 seconds in order
to bring all values to that of default.
7
E
XAMPLES
7.1 Example 1 – Service without
start/pause button
When you wish to provide users with a service (for
example,
a
characteristics:
Duration of service for 6 minutes.
•
Give the user 30 seconds of time for arriving
•
at the service before activation.
Warn the user that the service is about to be
•
terminated by interrupting it for 2 seconds at
1 minute before the end of service.
First enter into programming by pressing the
PROG. button (see ch. 4).
Set the service time to 6 minutes by following the
instructions in ch. 5.3.
To activate the service with a delay of 30 seconds,
set the manual pause as indicate in ch. 5.4
(Without the start/pause button the manual pause
corresponds to the delay of service).
Pag. 10 / 51
and
buttons set a value other
shower)
with
the
F
AVERO
following
E
D
LECTRONIC
ESIGN
Publicité
