Publicité
Atik R1
User manual
Thank you for purchasing the Lightpro Atik R1.
This document contains the required information for
correct, efficient and safe use of the product. Consult the
user manual of your transformer for more information
about the installation and connection of your lighting
plan or visit our website www.lightpro.nl
Read the information in this manual carefully before
using the product. Keep this manual near the product for
consultation in the future.
PRODUCT DESCRIPTION
The Lightpro Atik R1 is an LED spot for outdoor use. The
fixture can be mounted on a solid surface or placed in
the ground with the supplied spikes. This product may
only be used as outdoor lighting in combination with
the Lightpro 12-volt system. Any alterations made to the
product may have consequences for the safety, guarantee
and correct functioning of the product and/or other parts
of the system.
SPECIFICATIONS
Product
Article number
Light source
Power (max)
Luminous flux (max)
Light colour
Average lifetime
Dimensions (H x Ø)
Protection class
Ambient temperature
Cable length
Dimmable
Light source
On/off
PACKAGING CONTENT
[Figure A]
1. Fixture Atik R1
2. Ground tube
3. Lightpro connector
4. Alternative reflector
Check if all parts are present in the packaging. For
questions about parts, service, and any complaints or
other remarks, you can always contact us.
E-mail: info@lightpro.nl
Lightpro Atik R1
186U
LED 9W AC/DC 12V
9W
65 - 750 lm
3.000K
25.000
115 x120 mm
IP67
-20 °C to 50 °C
1m
Yes, with built-in dimmer
Not replaceable
10.000
INSTALLATION
Option 1: placement in de ground
[Figure B]
1. Place the ground tube in the ground.
2. Place the fixture in the ground tube.
The push button for setting the built-in dimmer is
located at the underside of the fixture. To control the
dimmer, the fixture has to be (temporarily) removed from
the ground tube. When installing, sufficient cable length
has to be reserved to be able to reach the dimmer.
Option 2: placement in a fixed underground
[Figure C]
1. Drill a hole (Ø100 mm) in the underground.
2. Place the fitting in the drilled hole. The ground tube
does not need to be used.
ADJUSTING BEAM DIRECTION AND/OR CHANGING THE
REFLECTOR
The pre-installed reflector has a beam angle of 60°.
If desired, it can be replaced by the included alternative
reflector, which has a beam angle of 23°.
[Figure D]
1. Unscrew the cover ring.
2. Remove the cover ring from the fixture.
[Figure E]
1. Unscrew the reflector.
2. Remove the reflector.
3. Place the alternative reflector (Figure A [4]).
4. Fasten the reflector.
[Afbeelding F]
The light source is secured in place by a spring
mechanism.
1. Pull the light source holder away from the fixture,
putting tension on the spring.
2. Keep the spring in tension, and move the holder of the
light source to the desired position.
[Afbeelding G]
1. Place the cover ring on the fixture.
2. Properly fasten the cover ring.
DIMMER FUNCTION
The fixture is equipped with a built-in dimmer. The
light output can be set to 6 different levels.
[Figure H]
1. Push the button to set the desired light output.
Publicité
