Frama ACCESS B350 Mode D'emploi page 11

6.1.1 Press down the letter release button (9) on the protec-
tive cover (10) while carefully pulling out the letter
against the normal feed direction, i.e. to the left. Then
let go of the letter release button (9).
The letter opener is once more ready for opera-

tion.
Attention! Do not use fingers in attempts to remove residu-
al scraps of paper from the slitting mechanism
(11) under the protective cover (10) (risk of injury). Also, do not use a hard or pointed ob-
ject for this purpose (risk of damage). In this case proceed according to 6.2 below.
6.2 Removing paper scraps
If scraps of paper become jammed in the slitting mechanism (11) under the protective cover (10), for
example from a damaged letter that has been fed into the machine, proceed as follows:
6.2.1 Switch off the letter opener at the mains switch (3) and
disconnect the power supply unit (1) from the power
connector (2).
6.2.2 Carefully insert the rod (13) from the accessory box
into the opening (14) at the rear of the machine, until
slight resistance is felt (press it down gently during in-
sertion). Maintain this pressure while sliding the pro-
tective cover (10) approx. 5 mm to the left, then pull it
away to the front.
Attention! The diode (4) blinks if the protective cover (10) is removed without first switching off the
letter opener. Switch off the letter opener before attempting to remove paper scraps!
6.2.3 Carefully remove the paper scraps.
6.2.4 Refit the protective cover (10): insert the four lugs (15)
in their corresponding openings (16) and slide the cov-
er to the right until it clicks into place.
6.2.5 The letter opener is ready for further use.
7. Accessories
Letter collecting tray

Power supply unit

Country-specific mains cable

Rod

Operating guide

Frama Access B350 / B400
9
10
14
10
13
16
15
10
11