Greencut EB260X Manuel D'utilisation page 47

BOX CONTENTS
1. Blower
2. Blower tubes
3. Instruction manual
• Remove the product and accessories from the box carefully. Make sure all the items listed above are present.
• Inspect the product carefully to make sure it has not suffered any breakage or damage during transport.
• Do not discard the packaging material until you have thoroughly inspected the product and used it satisfactorily.
ATTENTION: If any part is missing or damaged, contact the Official Technical Service. Do not use
this product without having replaced the missing or damaged part. Using this product with
damaged or missing parts can cause serious injury to the operator.
ASSEMBLY
Connect the two blower tubes together. To connect the two blower tubes, the tube (A) must be inserted into the tube
(B) in such a way that it fits perfectly into the tube (B) as shown in the drawing. Once this is done, rotate the tube (B)
following the notches until the anchor reaches its stop.
Insert the two joined tubes into the air outlet all the way down and repeat the above operation so that the pieces fit
together. Then tighten the screws (or screw) (C) to secure the tube anchorage.
A
C
B
47
EN