Publicité
Les langues disponibles
Les langues disponibles
T
ROUBLESHOOTING
FAQ
Question
My remote control does not work.
What should I do?
How come the Initial setup appears every
time I turn on this unit?
Why I cannot watch some of TV programs?
How come there is no image from the
connected external devices?
Whenever I entered channel number,
it changes automatically.
My disc cannot be played back.
Is there any way I can play my disc?
Why are captions not displayed entirely?
Or, captions are delayed behind the
dialogue.
How can I set the clock ?
Answer
•
Check the antenna or cable connection to the main unit.
•
Check the batteries of the remote control.
•
Check if there is an obstacle between the infrared sensor window and the
remote control.
•
Test the signal output. If OK, then possible infrared sensor trouble.
(Refer to "IR Signal Check" on page 54.)
•
Aim the remote control directly at the infrared sensor window on the
front of the unit.
•
Reduce the distance to the unit.
•
Re-insert the batteries with their polarities (+/– signs) as indicated.
•
When there is an infrared-equipped device such as PC near this unit, it
may interrupt the remote control signal of this unit.
•
Move the infrared-equipped device away from this unit, change the angle
of the infrared sensor or turn off the infrared communication function.
•
Connect the RF coaxial cable to the unit directly and run the initial setup.
•
Make sure to complete the channel scan before turning off the unit.
•
Make sure autoprogram has been completed.
(Refer to "Autoprogram" on page 22.)
•
Autoprogram must be completed when you set up the unit for the first
time or move it to a location where previously unavailable channels are
broadcast.
•
The selected channel may not be broadcasting.
•
When autoprogram is interrupted and not completed,
some channels will not be received. Make sure to complete.
(Refer to "Autoprogram" on page 22.)
•
The selected channel cannot be viewed by the "Child Lock" setting.
(Refer to ''Child Lock" on page 30.)
•
The unit requires some kind of antenna input. An indoor antenna (rabbit
ears), an external antenna, or an RF coaxial cable from your wall or cable
receiver/satellite box needs to be plugged into the unit.
•
Check if the right input mode is selected by pressing [SOURCE] or using
+
-
[CH
/
]. (Refer to "Switching Each Input Mode" on page 19.)
•
Check the antenna or cable connection to the unit.
•
Many digital channels have alternate channel numbers. The unit changes
the numbers automatically to the ones signifying the broadcasting
stations. These are the numbers used for analog broadcasts.
•
Clean the disc.
•
Ensure the disc is correctly inserted.
•
Check if the disc is defective by trying another disc.
•
Cancel the parental lock or change the control level.
•
Insert a correct disc that plays back on this unit.
•
Handle a disc with special care so that it does not have fingerprints,
scratches or dusts on its surface.
•
Captions that are delayed a few seconds behind the actual dialogue are
common for live broadcasts. Most captioning production companies can
display a dialogue to maximum of 220 words per minute. If a dialogue
exceeds that rate, selective editing is used to insure that the captions
remain up-to date with the current TV screen dialogue.
•
There is no clock function on this unit.
51
EN
Publicité
