Starfish S11560 Instructions D'installation

STARFISH SMART WIFI
™
LOW PROFILE DOWNLIGHTS
Models: S11560, S11561, S11562, S11563, S11564, S11565, S11566, S11567
INSTALLATION AND SAFETY INSTRUCTIONS
IMPORTANT: Read before installing fixture. Retain for future reference.
WARNING: Risk of Fire or Electric Shock
• Disconnect power before installation or any maintenance of
the fixture.
• To avoid damage, falling, electric shock or fire, do not modify the
fixture or replace accessories without confirming with the supplier first.
• Only authorized, qualified personnel should install this fixture and
should follow the owner's manual.
• Do not dismantle the fixture without the supplier's authorization.
• Do not touch the power supply when the fixture is operating.
• For use in environments where an accumulation of non-conductive
dust on the fixture may be expected.
• Suitable for indoor installations
IMPORTANT:
This product must be installed in accordance with the
applicable installation code by a person familiar with the construction and
operation of the product and the hazards involved.
Model Dim/Shape Watts
S11560 4"/Round
S11561 4"/Square
S11562 6"/Round 12W
S11563 6"/Square 12W
S11564 4"/Round
S11565 4"/Square
S11566 6"/Round 12W
S11567 6"/Square 12W
INSTALLATION
TOOLS REQUIRED: Hole saw, measuring tape and connector cables (as needed).
NOTE: Use extensions if necessary. Available connector cables are 6' (1.8m).
Connector cables are linkable.
1. Turn power OFF from the electrical panel before starting installation.
2. Cut a hole in the ceiling for the downlight in a suitable position. Refer to Hole Cut
Dimension chart (below).
3. Run the electrical wire from the switch (power supply wire) through the mounting
hole. Use NMD90 Romex or BX cable. See Figure A.
4. Open the Junction Box swing cover and remove the appropriate knockouts.
5. Insert the power supply wire through the knockout and fasten with a cable
connector (not included).
6. Connect wires inside the Junction Box using the quick connect terminals. Connect
green ground with the green box wire. Connect the black and white power leads
with the matching black and white box wires. See Wiring Diagram.
7. Put all wires and connections back into the box and close the cover securely.
8. New Construction Applications: Junction Box shall be firmly secured to the
studs, joists or similar fixed structural units.
Remodel Applications: Do not require the Junction Box to be firmly secured to
fixed structural units. Insert the Junction Box into the ceiling.
9. Bend back the two torsion springs and slowly fit the fixture through the ceiling hole.
The torsion springs will pull the fixture into place. See Figures B & C.
10. Once installation is complete, turn power ON to confirm the fixture is working properly.
11. App Connection: To connect your device, download the free "Starfish Smart
Lighting" App from the app store. Please refer to our Starfish User Guide for
detailed instructions on how to pair your device.
Hole Cut Dimensions:
4" Round and square: Ø 4 1/4" (108mm)
6" Round and square: Ø 6 5/16" (160mm)
© Copyright 2023 Satco Products, Inc. 4/23 v1.3
.
Volts CCT
9W
9W
RGBTW
120V
2000-5000K
9W
9W
CRI Finish
White
90
Download the STARFISH App
Fixture Includes:
1 LED Lamp and 1 Junction Box
WIRING DIAGRAM
Satco Products, Inc.
Brentwood, NY 11717
Figure A
Figure B
Figure C