DEFECT TYPE
The pump will not start
The pump does not stop
Intermittent pump operation (red led)
The pump is blocked
CAUSES THAT DEPEND ON PRESSURE
SWITCH
- Damaged electrical cable.
- The electronic board is damaged;
- The electronic board is damaged;
- Flow detector blocked in upper
position;
- Reset button locked;
- The pump does not provide
sufficient pressure.
- The electronic board is damaged;
- Pump with insufficient pressure;
- The electronic board is damaged;
- The pressure supplied by the pump
is less than the reset pressure;
CAUSES NOT DEPEND ON PRESSURE
SWITCH
- Power failure;
- Blocked pump;
- Inverted electric cables;
- Existence of leaks in the pipeline,
greater than the minimum flow of 2
L/min.
- The water flow is less than the
minimum flow of 2 L/min;
- Water failure;
- Suction problem;
- Water failure;
- Suction problem;