Yealink MeetingBar A10 Guide De Démarrage Rapide page 8

7
Device Mode
1. Do one of the following to select Device Mode:
• When selecting a platform during power-on initialization, select Device Mode.
• After logging in, you need to reset to factory before switching platforms:
Teams: Go to More > Settings > Device Settings > System, enter the admin password (0000),
and select Reset to factory.
Zoom: Go to Settings > General > System Settings > System, enter the admin password (0000),
and select Reset to factory.
Wireless Content Sharing
2. Refer to the
8
WPP30
WPP30 cannot be used when the endpoint uses a wireless network.
i
Wireless Content Sharing
1. Connect the WPP30 to the
MeetingBar A10. Waiting for 3 seconds, MeetingBar A10
prompts "Wireless presentation pod pairing successfully".
2. Connect the WPP30 to the
of PC and press the Presentation button to share the
screen.
Wireless Device-USB Mode
If on Teams mode, please refer to steps 1, 2, and 3 in
the Firmware
System > UC Provider to enable Device Mode Enable.
1. Connect the WPP30 to the
MeetingBar A10. Waiting for 3 seconds, MeetingBar A10
prompts "Wireless presentation pod pairing successfully".
2. Connect the WPP30 to the
of the PC, and do one of the following on the Yealink
Wireless Presentation Pod Software:
• On Teams/Zoom mode, click BYOD Mode > Press to
share.
• On Device Mode, click Press to share.
USB-A
port of the
USB-A
port or
section to enter the web interface, and enter
USB-A
port of the
USB-A
port or
section.
USB-C
port
Update
USB-C
port
6
Device Mode Video
Wireless Content Wireless Content
Sharing Video (Teams)
Sharing Video (Zoom)
Presentation button
PC
WPP30
Wireless Device Wireless Device
USB Mode Video USB Mode Video
(Teams)
(Zoom)