Publicité
Les langues disponibles
Les langues disponibles
EN
INSTRUCTIONS MANUAL
Ref. TE DIN 220
230V~ MODULAR IMPULSE RELAY
TECHNICAL CHARACTERISTICS
Tensão de controlo
Contact
Switching Capacity
LED
230V Incandescent /
Halogens
12V Halogens
with transformer
Fluorescent tubes
Pushbuttons
with glow lamp
Coil consumption
Minimum time
between impulses
Minimum time
between impulses
Mechanical lifetime
Electrical lifetime
Dimensions
Working temperature
Protection degree
According
to the Standard
DESCRIPTION
● Impulse relay with 1 NO free-voltage contact.
● 1 module DIN rail mounting.
● The output contact changes its status when the coil is supplied
through the pushbutton. That is, a press closes its contact and the
next press opens it.
● Unlike a contactor, the coil of the switch does not remain under
voltage and there is no permanent power consumption.
● Very low sound level, so silence.
● Application examples: hotel and hospital rooms, homes, corridors,
etc.
**NOTE: It is possible to use the accessory AC DM- 003 to increase
the number of pushbuttons with glow lamp, although this reduces
the response frequency of the impulse relay.
DIMENSIONS
WIRING DIAGRAMS
Work with electrical equipment on the 230V mains
must be carried out exclusively by qualified
technicians!.
Disconnect the mains voltage before proceeding to the
assembly, disassembly or manipulation of the
electrical device!.
● Follow one of the following wiring diagrams at the time of the
electrical installation:
max.: 6mA
DINUY, S.A. Auzolan, 2, 20303, IRUN, SPAIN
TE DIN 220
230V~
90
16A
250V~
Made in EU
17,5
WARNING: Hazardous voltage!.
N
L
Declaration of conformity CE
www.dinuy.com
230V~ 50/60Hz
NO Unipolar free-voltage contact
16A / 230V~
3.000W
3.000W
600W (60µF)
Up to 3 (up to 10 with AC DM- 003)
Working: 0VA
Pulsation: 7mW
0,1sec (maximum 20 per minute)
> 1 milhão de manobras completas
With maximum load: > 50.000 cycles
17,5 x 53 x 90mm
-20ºC ~ +45ºC
EN 60669-2-1
5
7
1
3
Guarantee
400W
0,05sec
IP20
60
6
8
2
4
Publicité
