SNOWJOE SUNJOE SPX4600-MAX Manuel De L'opérateur page 8

5. Fix the assembly with the thumb screw, washer, and nut
as shown. Tighten to secure (Fig. 4).
Fig. 4
Washer
Thumb screw
6. On the back right side of the upper handle frame, place
the trigger gun holder and align the holes (Fig. 5). Fix with
the other set of thumb screw, washer and nut (Fig. 6).
Fig. 5
Trigger gun
holder
Fig. 6
Thumb
screw
Washer
7. Slide the upper handle frame assembly into lower handle
frame assembly, then depress the small button at the
end of the lower handle frame, push and insert into upper
handle until it snaps securely into place (Fig. 7).
Nut
Nut
Fig. 7
Lower handle
frame assembly
8. Fit the stainless steel lance into the trigger gun and rotate
the collar until the two parts are completely locked (Fig. 8).
Fig. 8
Trigger gun
Stainless
steel lance
9. Connect the high-pressure hose to the trigger gun (Fig. 9).
Fig. 9
High-pressure hose
10. Connect the other end of high-pressure hose to the water
outlet on the washer (Fig. 10).
8
Upper
handle
frame
assembly
Collar
Trigger gun