Publicité
Les langues disponibles
Les langues disponibles
SAFETY INFORMATION
WARNING
• Risk of fire or electric shock. 120V light installation requires knowledge of luminaires electrical systems. If not
qualified, do not attempt to install. Contact a qualified electrician.
• Disconnect power at fuse or circuit breaker before installing or servicing.
• No user serviceable parts inside. To avoid electrical shock, do not disassemble product.
• To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
• Use only on 120V AC, 60 Hz circuits and with maximum 75W light bulb
PREPARATION
• Before beginning assembly of product, make sure all parts are present. Compare parts with package contents
list. If any part is missing or damaged, do not attempt to assemble the product.
• Tools needed:
Phillips screwdriver
Step ladder
Silicone sealant (optional)
INSTALLATION
1
Disconnect power at fuse or circuit breaker
before installing the light. Ensure fixture
screws and nuts are inserted into the bracket
as shown. Adjust the swivel angle based on
your juction box.
3
Use the screw length indicator to adjust the
length of the two long screws. Then, tighten
the two nuts.
2
Tighten middle screws in the bracket so it's firm and doesn't
wobble. Fasten bracket to junction box using 2 junction box
screws. Choose short or long as needed.
4
Use the holding hook to suspend the light fixture and free
up both hands for wiring. Connect the bottom of the hook
(square) to the right screw pole. Hang the top of the hook
onto the mounting bracket.
3
Publicité
