Publicité
Les langues disponibles
Les langues disponibles
3. Turn on or plug in the power supply to the hot water dispenser.
The unit fills at the approximate rate of 1 gallon (3.8 L) per
minute, depending on water line pressure.
4. Heat and discard at least one tank of water.
DEFAULT SETTINGS
• Temperature: 150°F/65°C
• Unit of measurement for temperature: Fahrenheit
• Water connection: Plumbed into water supply
• Night mode temperature: fixed at 158°F (70°C)
OPERATING INSTRUCTIONS
SETTING THE TEMPERATURE
1. Press
2. Use the
3. O nce desired temperature is displayed, press the
to set or wait 10 seconds to set new temperature.
4. Display will show set temperature and PRESS START blinking.
5. Press
CAUTION: Water is very hot. Use caution when pouring or
transporting hot water. Accidental spills may result in severe burns.
SETTING °F/°C
1. Press
2. Once in program mode, PRESS and HOLD the
for 2 seconds.
3. Use the
4. O nce desired unit of measure is selected, press
to set.
5. If neither button is pressed for 15 seconds, then the F or C
displayed will be programmed.
SETTING THE CLOCK
1. To set the clock, press and hold the
2 seconds.
2. Use the
3. O nce the desired time is displayed, wait 10 seconds, and the
time will be set. Display will show set time for 3 seconds.
button once.
arrows to reach your desired temperature.
to begin filling and heating water.
button once.
arrows to switch from F to C.
arrows to scroll.
button for
9
button
button
twice
Publicité
