TO REPLACE GROUND DRIVE BELT
(See Fig. 23)
•
Remove belt guard (See "TO REMOVE BELT GUARD"
in this section of this manual).
•
Remove old belt by slipping off engine pulley first then
remove from transmission pulley.
•
Place new belt in groove of transmission pulley and
into engine pulley. BELT MUST BE IN GROOVE ON
TOP OF IDLER PULLEY. NOTE POSITION OF BELT
TO GUIDES.
•
Check belt adjustment as described below.
•
Replace belt guard.
•
Reposition wheel and replace clevis pin and hairpin
clip.
Get user manuals:
See SafeManuals.com
SERVICE AND ADJUSTMENTS
ENGINE
PULLEY
IDLER
TRANS MIS SION PULLEY
PULLEY
GROUND DRIVE BELT ADJUSTMENT
(See Fig. 23)
For proper belt tension, the extension spring should
have about 5/8 inch stretch when drive control bar is in
"EN GAGED" position. This tension can be attained as
follows:
•
Loosen cable clip screw securing the drive control
cable.
•
Slide cable forward for less tension and rearward for
more tension until about 5/8 inch stretch is obtained
while the drive control bar is engaged.
•
Tighten cable clip screw securely.
EXTENSION
SPRING
Fig. 23
15
CABLE CLIP
SCREW
DRIVE
CONTROL
CABLE
LESS
TEN SION
MORE
5/8"
TEN SION