Publicité
Les langues disponibles
Les langues disponibles
1.
Remove the battery earth cable.
Remove the covering in the boot.
Open the entrance to both rearlight units.
2.
Drill a 13 mm large hole just behind the socketplate of the towbar, or use an existing rubber grommet.
Remove carefully all metal particles around the hole and treat it with anti-rust paint.
Fit the rubber grommet in the hole.
3.
Route the wiringharness in the boot and lead the 8-pole end through the rubber grommet to the socket.
Pull the coverplate over the wiringharness.
Remove the contactholder from the socket and fit the wires as follows:
Trailer lighting:
Left turn signal
Rearfoglight
Earth
Right turn signal
Right taillight
Brakelights
Left taillight
Rearfoglight
Mount the socket to the towbar.
4.
Near both rearlight units 6-pole connectors are located.
Disconnect the connectors at the right side.
Connect the wiring harnesses connectors with the green and brown wire correspondingly.
Disconnect the connectors at the left side.
Connect the wiring harnesses connectors with the blue, grey, red, black and yellow wire correspondingly.
Fit the white wire to chassis earth.
5.
Reconnect the battery and check all electric functions, with trailer/caravan connected.
Reinstall disassembled parts.
©ECS1999
FITTING INSTRUCTIONS ELECTRIC WIRINGKIT TOWBAR WITH 12-N SOCKET UP TO
DIN/ISO NORM 1724
NISSAN SUNNY 100NX 1991-
HATCHBACK N14 3/5 DOORS SEDAN B13
Partno.: NIS-056-B
Pin No.:
Wire colour:
1 (L)
yellow
2 (54-G)
blue
3 (31)
white 2,5 mm2
4 (R)
green
5 (58-R)
brown
6 (54)
red
7 (58-L)
black
8 (58-b)
grey
NIS-056-B-E
061299M
1
8
STOP
2
6
7
3
5
4
REVISIE 0
Publicité
