Publicité
Les langues disponibles
Les langues disponibles
honey joy
GETTING STARTED
1
Open the carton from the top and remove the bicycle.
2
Remove the straps and protective packaging from the bicycle.
Important! Do not discard packing materials until assembly is
complete to ensure that no required parts are accidentally
discarded. NOTE: The bike comes with some plastic pieces to
protect the bike.
3
Inspect the bicycle and all accessories and parts for possible
shortages. It is recommended that the threads and all moving
parts in the parts package be lubricated prior to installation.
Note: We recommend using
a lithium based grease on the
parts before assembly.
Pedals
Training
wheels (a pair)
03
Doll chair
Handlebar
assembly
Seat
Doll chair assembly
Seat post
Wrench
GUIDE FOR ASSEMBLING THE
BIKE
1
Preparation
Tools needed: Please open the carton from
the top. Take out the bike and all parts. Find
the small tool case and open it. Take out
the tools from the tools case. You will also
need a knife or scissors to cut the fixing tapes on the bike and
parts. Take care not to scratch or mark the bike.
Fixing the training wheels
2
Remove the protective caps on the axle of the rear wheel.
Unscrew the nuts, and put the training wheel on. Then screw on
nuts again.
Note: Before the nuts are fully tightened, you can adjust the
training wheel up or down to make the bottom of the training
wheel have a clearance less than 0.2"(5mm) up from ground.
honey joy
positioning
washer
04
Publicité
