Publicité
Les langues disponibles
Les langues disponibles
INCLUDED COMPONENTS
a
b
3pcs
1pc
4pcs
f
4pcs
1pc
"U" shaped bracket (cable)
c
Long screw nail
Short screw
d
e
Short tube
BEFORE STARTING ASSEMBLY, MAKE SURE ALL
COMPONENTS LISTED ARE IN THE PACKAGE.
TOOLS REQUIRED
Pencil
Screwdriver
06
c
d
4pcs
g
h
4pcs
4pcs
Plastic expander
f
g
Allen wrench
Set screw
h
i
Replacement
Hammer
Tape measure
Levelling instrument
Electric drill
e
4pcs
i
1. Remove short screw (d) near the power cable of towel warmer.
2. Insert short screw (d) through the hole of "U" shaped bracket (b).
&
3. Screw down short screw (d) by screwdriver to fix the "U" shaped
bracket (b) on the back of the towel warmer.
1pc
Note: When installing unit, the set screws of the bracket should
towards floor.
4. Fix remaining three normal brackets (a) to the towel warmer by
repeating step 2 to 3.
5. Place the towel warmer on the wall, use levelling instrument to
test levelness and perpendicularity to confirm the perforation
position of the wall, and then mark A, B, C, D on the wall.
Suggest it is installed at least 23.62 inches (600mm) above the floor
level.
INSTALLATION STEPS
b
d
CAUTION — SURFACE OF UNIT IS HOT WHEN ON !
a
a
≥23.62 inches
(600mm)
a
b
d
d
07
Publicité
