Publicité
5.4 INSTALLATION: Eave Mount (External Junction Box)
STEP 1: Disconnect power supply.
Remove (2) plastic plugs. Remove
inserted (2) M5*12 screws, (2) M5 Flat
washers and mounting plate. Attach
junction box on the wall (not supplied).
STEP 4: Secure fixture onto mounting
plate with inserted (2) M5*12 screws, (2)
M5 Flat washers and plastic plugs.
6. Turn ON Power at the Breaker
After connecting power supply, the lights will turn on and your Starfish Security Floodlight Camera will make a sound to
indicate that it's in pairing mode.
TROUBLESHOOTING
1. Check your power source.
2. Check electrical connections.
3. Check that the motion sensor is working properly.
7. Connection Preparation
Please install the Starfish Security Floodlight Camera in an area that has adequate Wi-Fi signal to ensure the best
product performance.
Camera
NOTE: Please refer to Starfish User Guide for detailed product pairing instructions. This product requires a 2.4GHz Wi-Fi
connection for proper operation.
© Copyright 2023 Satco Products, Inc. 3/23, v4.0
STEP 2: Fix mounting plate and
gasket onto junction box with (4)
#10-1inch screws.
STEP 5: Adjust the horizontal
position angle of the fixture by
loosening (2) 4*12 screws. After
adjustment, tighten (2) M4*16
screws.
Router
4
STEP 3: Connect the wires with
(3) P3 Wire Nuts. Refer to the
same Wiring Diagram as Wall
Mount (Built-in Junction Box).
STEP 6: Adjust the vertical angle
by loosening (2) hand nuts on
both sides. After adjustment,
tighten (2) hand nuts. Check
fixture and connect power supply.
Smartphone
Publicité
